StuRa Diskussion:Install-Party/FreeBSD: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
(Neuer Abschnitt →unbekannte Fehler) |
(Neuer Abschnitt →FreeBSD 12 on thinkpad X60 tablet) |
||
| Zeile 2: | Zeile 2: | ||
: <code>error: [drm:pid''1010'':gen6_sanitize_pm] *ERROR* Power management discrepancy: GEN6_RP_INTERRUPT_LIMITS expected 1a0d0000, was 1a000000</code> | : <code>error: [drm:pid''1010'':gen6_sanitize_pm] *ERROR* Power management discrepancy: GEN6_RP_INTERRUPT_LIMITS expected 1a0d0000, was 1a000000</code> | ||
== FreeBSD 12 on thinkpad X60 tablet == | |||
; rc.conf | |||
<pre> | |||
clear_tmp_enable="YES" | |||
sendmail_enable="NONE" | |||
hostname="x60james" | |||
keymap="german.iso.kbd" | |||
ifconfig_em0="DHCP" | |||
ifconfig_em0_ipv6="inet6 accept_rtadv" | |||
sshd_enable="YES" | |||
moused_enable="YES" | |||
ntpd_enable="YES" | |||
powerd_enable="YES" | |||
dumpdev="AUTO" | |||
zfs_enable="YES" | |||
apm_enable="YES" | |||
wlans_wpi0="wlan0" | |||
ifconfig_wlan0="WPA DHCP" | |||
dbus_enable="YES" | |||
hald_enable="YES" | |||
slim_enable="YES" | |||
wacom_enable="YES" | |||
devd_enable="YES" | |||
</pre> | |||
; /boot/loader.conf | |||
<pre> | |||
aesni_load="YES" | |||
geom_eli_load="YES" | |||
kern.geom.label.disk_ident.enable="0" | |||
kern.geom.label.gptid.enable="0" | |||
zfs_load="YES" | |||
#if_ath_load="YES" | |||
legal.intel_wpi.license_ack=1 | |||
wpifw_load="YES" | |||
if_wpi_load="YES" | |||
firmware_load="YES" | |||
wlan_amrr_load="YES" | |||
#if_wpi_load="YES" | |||
### maybe needed for tablet foo | |||
cuse4bsd_load="YES" | |||
</pre> | |||
Version vom 26. Mai 2017, 23:10 Uhr
unbekannte Fehler
error: [drm:pid1010:gen6_sanitize_pm] *ERROR* Power management discrepancy: GEN6_RP_INTERRUPT_LIMITS expected 1a0d0000, was 1a000000
FreeBSD 12 on thinkpad X60 tablet
- rc.conf
clear_tmp_enable="YES" sendmail_enable="NONE" hostname="x60james" keymap="german.iso.kbd" ifconfig_em0="DHCP" ifconfig_em0_ipv6="inet6 accept_rtadv" sshd_enable="YES" moused_enable="YES" ntpd_enable="YES" powerd_enable="YES" dumpdev="AUTO" zfs_enable="YES" apm_enable="YES" wlans_wpi0="wlan0" ifconfig_wlan0="WPA DHCP" dbus_enable="YES" hald_enable="YES" slim_enable="YES" wacom_enable="YES" devd_enable="YES"
- /boot/loader.conf
aesni_load="YES" geom_eli_load="YES" kern.geom.label.disk_ident.enable="0" kern.geom.label.gptid.enable="0" zfs_load="YES" #if_ath_load="YES" legal.intel_wpi.license_ack=1 wpifw_load="YES" if_wpi_load="YES" firmware_load="YES" wlan_amrr_load="YES" #if_wpi_load="YES" ### maybe needed for tablet foo cuse4bsd_load="YES"